As in the previous step, no portion of the lumber should exceed the plywood’s sides. It should also align with the sloping side of the plywood. Begin by drilling one 2×4 at the topmost part of the ramp and between the two plywood walls. Now, we have the bottom side of the ramp framed with two 2×4 lumbers.Īt this point, we’ll frame the ramp side of this kicker obstacle. Repeat the same process with the other plywoods. Ensure that no part of the lumber exceeds the sides of the plywood.ĭrill through the plywood to fix the lumbers against it. That means the second 2×4 stands along with the 2′ side of the plywood. Align the 1 1/2″ end with the first lumber we laid. The 1/2″ plywood we cut has a 2′ and 1 1/2″ vertical side with the broad side facing sideways. Such will serve as the back bottom side of the ramp. Put another 23-inch lumber at a distance approximately the same as the length of the plywood. In this stage, we’ll fix the walls of the DIY kicker ramp and its front and back bottom brace.īegin by placing one 2×4 with the broader side against the ground. Refer to the figure below for a rough idea of how the ramp will look. You have already completed the kicker ramp’s walls. Trace the first wall against another plywood and cut through it. You now have a piece of the ramp’s walls plywood. Cut through the plywood following the line drawn. Lay it flat and draw a diagonal line from the tick mark to the opposing upper corner. Put a tick mark on the 2′ edge 1 1/2″ away from that long side of the plywood. Cut through the board and leave a 3′ and 5″ length. Our goal is to have six pieces of this wood at 23″ long. Should you have bought a 2×4 with a length different from the one specified, you may cut it. Remember that we prepared 2×4 lumber and plywood. Making a Portable Kicker Ramp: Step by Step Step 1: Cutting the wood Cutting tools – Finally, we need sharp edges and tips in a circular saw and various drill bits to cut through wood.Thus, prepare a measuring or steel tape and pencil. Measuring tools – We should measure our parts before making necessary cuts.So, prepare enough screws with sizes of 1″, 1 1/2″, and 2 3/4″ Hardware – The wooden wedge ramp we’re making may be small, but adhesives won’t secure it well enough.Building materials – We need one thin 3/16 metal sheet at 4 ft x 10″ to serve as the entry point of the skateboard.Your wood materials should consist of six 23-inch long 2×4 lumber pieces plus one 1/2″ plywood cut into four 2×4 parts. Wood – The primary material for our ramp is wood.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |